Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 2 (kliknij aby zobaczyć)
UNPACKING
1. Carefully unpack the speakers. If you suspect damage from transit, report it immediately to your dealer and/or delivery service. Keep the shipping carton and packing materials for future use. 2. Verify that the package includes the following items: � (2) Outrigger Speakers � (2) Mounting Brackets � (2) Paint Masks � (1) Owner�s Manual
PLACEMENT
Although Outrigger Outdoor Speakers are weather-resistant, they are not weatherproof. We recommending placing or mounting them in a protected location, such as under the eaves of a roof or on a porch. For the best stereo effect, separate your Outrigger speakers by at least seven to ten feet. Use the built-in pedestal for placement on a table or other surface (see Figure 1). Experiment with different placement to find the most pleasing effect for your system. Placing your speakers near a wall or other surface will increase bass output. For vertical or horizontal mounting on a wall, use the enclosed mounting bracket and hardware (see Figures 2 and 3). Locate a stud for secure mounting. Use heavy-duty screws with long threads (not included) so there is an adequate number of threads holding the speaker/bracket to the wall. Test the mounting thoroughly before final installation. Rotate the logo (on the grille) to match the mounting position.
NOTE: After determining placement position, you may wish to paint each speaker (see next section).
OUTRIGGER (Front View)
rotate logo
FIGURE 1. Use the built-in pedestal for placement of an Outrigger speaker on a table or other surface. Note logo orientation.
OUTRIGGER (Rear View)
OUTRIGGER (Rear View)
Wood Screws (fasten to wall stud)
KNOB (1 of 2)
MOUNTING BRACKET
KNOB (1 of 2)
MOUNTING BRACKET
Wood Screws (fasten to wall stud)
FIGURE 2. Vertical wall mounting of an Outrigger speaker. If desired, tilt the speaker left or right before tightening knobs.
FIGURE 3. Horizontal wall mounting of an Outrigger speaker. If desired, tilt the speaker up or down before tightening knobs.
